daokai® 5pcs duplica H Puente DC motor paso Motor Controller Board Módulo para Arduino L298 N

daokai® 5pcs duplica H Puente DC motor paso Motor Controller Board Módulo para Arduino L298 N

daokai® 5pcs duplica H Puente DC motor paso Motor Controller Board Módulo para Arduino L298 N

  • La señal se muestra en la figura
  • La conexión método está demostrado inbelow figura después de activar ENA ENB
  • Conducción motor DC ya que el módulo se mediante doble H Puente DRIVED, se puede dos motores al mismo tiempo conduce.
  • Entrada lo siguiente de momento de accionamiento in1 de IN4 entonces se puede controlar la velocidad y la dirección del paso Motors,

L298 N is a Kind of High Voltage, High Current Motor Driver chip produced by St Company. having 15 pines as Package, this chip tiene características such as High working Voltage (máx Voltage Up To 46 V) grande, Output Current (Instantaneous Peak current Up To 3 a Continuous working current 2 a), and 25 W of Rated power. Two Built-in H birdge High Voltage and Large current Full Bridge Drivers can be used to Drive the DC Motor and Stepper Motor, relay Coil and so on.Using Standard Logic Level Control de señal, it has Two enable Control Ends. it permits or prohibites device having a Logic Power Supply Input without the Impact of Input señal, which enables the Internal Logic Circuit Part Works at Low Voltage. the chip can Connects to External Detecting Resistor to give the sutiles to the Control circuit. using L298 N chip to Drive the motor, this chip can Drive a Stepping Motor or Four fase Stepping Motor, and Two DC Motor as Well. Description: 1 using L298 N Made by St Company as The control chip, The Module has such as se adaptan Strong Driving ability, Low calorific Value and Strong anti interferencias ability. This Module can use Built en 78 M05 for Electric Work via a Driving Power Supply Part. but to avoid the damage of the Voltage stabilizing chip, please use An External 5 V Logic Supply when using more than 12 V Driving Voltage. 3 using Large capacity Filtro capacitor, this Module can Follow current to protect diodes, and Improve the reliability. This Module is Integrated with a Built-in 5 V Power V-35. when the Drive Voltage is 7 V, it can enable the Onboard 5 V Logic Power Supply; afterthe Power Supply, don ‘t Input Voltage in the Interface + 5 V Power Supply, but you can lead the 5 V for External use. when Ena enable Control in1 in2 OUT1 OUT2 when enb enable IN3 IN4 Control OUT3 OUT4 Applied Cases: 1 Driving Stepper Motor the connection of driving a Common 4 Line 2 Fase del motor eléctrico is Shown in below Figure after enable Ena enb

List Price: EUR 13,06

Price: EUR 13,06

Add a Comment

Your email address will not be published.

GTA 5 Lobby ARGENT

fiverr instagram bot

Fiverr Bot

Translate »